Fabricants d'alimentations électriques

PE280 de petite taille avec pilote de LED à gradation triac intégré conforme à l'ERP

PE280 is one of the constant current dimming LED driver developed by my company with high power factor ,high efficiency, high precision, the use of the efficient stable low loss switch control chip and the high performance components makes it with low noise, energy saving, environmental protection, long life and other characteristics.

  • Marque:

    QINX
  • Numéro d'article :  

    PE280B
  • Input Voltage:  1

    100-265Vac
  • Mode de fonctionnement:

     constant Current
  • Mode de gradation :  

    Triac dimmable
  • Taille:  

    47.5*35.2*29.3mm
  • Attestation :  

    SAA CE ROHS
Description des produits

Caractéristiques:

  • LED phase-cut dimming driver, dimming range 2-100%
  • Suitable for RPC MOSFET dimmer and FPC TRAIC dimmer
  • PFC actif
  • Protections: short circuit/over voltage/over current
  • Silica gel heat conduction technology,natural cold wind
  • Ultra small volume
  • Suitable for LED home lighting and commercial lighting
  • Safe no load protection device
  • Economic and convenient installation
  • conform to the world lighting equipment safety standards
  • Protection class II
  • 3 ans de garantie

General description:

PE280 is one of the constant current dimming LED driver developed by my company with high power factor ,high efficiency, high precision, the use of the efficient stable low loss switch control chip and the high performance components makes it with low noise, energy saving, environmental protection, long life and other characteristics.

█ Specification

Modèle     PE280B2435    PE280B4220     PE280B0670    PE280B1270     PE280B2430
   SORTIRTension de sortie     12-24Vdc    25-42Vdc     2.5-6Vdc    6- 12Vdc     12-24Vdc
Max Output Voltage     24Vdc    42 Vcc     6Vdc    12Vdc     24Vdc
Non-load Output Voltage     27Vdc    43Vdc     8Vdc    15Vdc     27Vdc
Courant de sortie     350mA    200mA     700mA    700mA     300mA
Puissance de sortie     4.2W~8.4W    5W~8.4W     1.75W~4.2W    4.2W~8.4W     3.6W~7.2W
Strobe Level      Lower flicker(8%)
Dimming Range      2~100%,
PWM Dimming Frequency
Current Accuracy      ±5%
Ripple & Noise      =500mv p-p
   SAISIRDimming Interface      Triac Leading edge/Tralling edge
Plage de tension d'entrée      200-250VCA
Fréquence      50/60Hz
Input Current      <0.08A    <0.08A      <0.08A      <0.08A<0.08A
Power FactorPF>0.9(at  full  load)PF>0.9(at  full  load)PF>0.88(at  full  load)PF>0.88(at  full  load)PF>0.88(at  full  load)
THD      230Vac@THD     <20% (at full  load)
      77%     79%      77%    77%      77%
Inrush Current(typ.)    Cold start0.8A   Cold start0.8A   Cold start1.54ACold start0.8A   Cold start0.8A
Anti Surge      L-N: 2kV
Courant de fuite      <0,25mA/230Vca
ENVIRONNEMENTWorking Temperature      ta: 55 °C  tc: 85  °C
Humidité de travail      20 ~ 95%RH, non-condensing
Storage Temp., Humidity      -40 ~ 80  °C   , 10~95%RH
      ±0,03%/°C(0-50)°C
Vibration      10~500Hz, 2G 12min./1cycle, period for 72min. each along X, Y, Z axes.
PROTECTIONOver-heat Protection      Intelligently adjusting or turning off the output current if the PCB temperature ≥110°C, , auto recovers.
Over Load Protection      Shut down the output when rated power≥102%, auto recovers.
Short Circuit Protection      Shut down automatically if short circuit occurs, auto recovers.
Non-load Protection      Shut down the output if no load, auto recovers when load back to normal.
SAFETY &
CEM
Withstand VoltageI/P-O/P: 3750Vac
Isolation ResistanceI/P-O/P: 100MΩ/500VDC/25°C/70%RH
Safety StandardsIEC/EN61347- 1, IEC/EN61347-2- 13
Émission CEMEN55015, EN61000-3-2 Class C, IEC61000-3-3
Immunité CEMEN61000-4-2,3,4,5,6,8,11,  EN61547
Strobe Test StandardIEEE 1789
   AUTRESDimension47.4×29.3×20.8/50mm(L×W×H/D)
EmballagePE  bag
Poids (GW)42g±5g

Dimensions :

Product Label:

Wiring Diagram:

PE280_D 2

█ Wiring:

The output wire: 20AWG red and black PVC cable ,length 200-230mm,wire stripping requirement:5-7mm

The input wire : 20AW Brown Blue VDE double insulated wire, length 150-160mm,wire stripping requirement:5-7mm

The use of guidance:

**1:please pay attention to the distinction betweeninput and output,connect correctly,then power on

**2: please connect first the load of the DC output, open the powersupply after checking; in the constant current mode, if power on at open circuit,please turn off the power supply and can’t connectthe LED until the electric energy stored by the output release , or it may damage the LED;

**3:this type of power supply is only limited to the use of the LED lamps and lanterns, the input voltage range is AC200-250V, the

Specified output voltage, current range, the use environment temperature is -20-45 degrees,and the surface can not cover the

heat insulation cotton and other items that obstruct the heat dissipation of the product, which conforms to the product under the

conditions of the environment, this product enjoys three yearsof free warranty.

The abnormal conditions and the corresponding treatment methods:

l, the LED lamp doesn’t bright after the dimming driver is connected at the first time ,please turn off the AC input and check as follow:

a) Si oui ou non un mauvais contact de sortie CC ;

b) Que la polarité de la sortie CC soit inversée ou que la carte LED soit soudée anti ;

c)Whether AC input is bad contact;test after eliminating these failures.

2, the device has good connection, LED lights, but the LEDflicker, please turn off the AC input, then check the DC output;

a) surcharge, sous charge.

b) Si les paramètres et les paramètres réels correspondent ou non.

3,please timely communicate with us if you any questions inthe using,we will try our best to solve the problems with you.

Statement:

Les images et les spécifications sont à titre de référence uniquement, en nature prévalent, les spécifications sont sujettes à modification avec préavis.

Laisser un message

    Pour en savoir plus sur nos alimentations/adaptateurs secteur/pilotes LED/chargeurs, veuillez nous envoyer un e-mail, nous vous répondrons bientôt.

    Produit associé
    Driver LED à gradation triac série PE294R 3-12W

    Driver LED à gradation triac série PE294R 3-12W

    PE294 is one of the constant current dimming LED driver developed by my company with high power factor ,high efficiency, high precision, the use of the efficient stable low loss switch control chip and the high performance components makes it with low noise, energy saving, environmental protection, long life and other characteristics.

    Driver LED à gradation triac 12-18W série PE296R

    Driver LED à gradation triac 12-18W série PE296R

    PE296 is one of the constant current dimming LED driver developed by my company with high power factor ,high efficiency, high precision, the use of the efficient stable low loss switch control chip and the high performance components makes it with low noise, energy saving, environmental protection, long life and other characteristics.

    Alimentation électrique TRIAC 100W 0-10V 2 en 1, variateur sans scintillement, pilote Led

    Alimentation électrique TRIAC 100W 0-10V 2 en 1, variateur sans scintillement, pilote Led

    It adopts CPU control and designs a variety of control modes. The dimming is slow on and off. The raw materials used are first-line brands and imported chip ultra deep dimming design,It matches a variety of intelligent dimming systems and dimmers on the market. Aluminum alloy shell, rapid heat dissipation, makes the thermal balance of components more stable.

    PE280 de petite taille avec pilote de LED à gradation triac intégré conforme à l'ERP

    PE280 de petite taille avec pilote de LED à gradation triac intégré conforme à l'ERP

    PE280 is one of the constant current dimming LED driver developed by my company with high power factor ,high efficiency, high precision, the use of the efficient stable low loss switch control chip and the high performance components makes it with low noise, energy saving, environmental protection, long life and other characteristics.

    Pilote LED à gradation triac de petite taille PE281 3-12W

    Pilote LED à gradation triac de petite taille PE281 3-12W

    PE280 is one of the constant current dimming LED driver developed by my company with high power factor ,high efficiency, high precision, the use of the efficient stable low loss switch control chip and the high performance components makes it with low noise, energy saving, environmental protection, long life and other characteristics.

    QINX

    Connecte-toi avec nous
    Si vous êtes intéressé par nos produits et souhaitez en savoir plus, veuillez laisser un message ici, nous vous répondrons dès que possible.
    Façon de nous contacter.

      Copyright © Qinx Technology Co., Ltd. Tous droits réservés.
      Bienvenue à QINX

        Pour en savoir plus sur nos adaptateurs d'alimentation/pilotes de LED/alimentations/chargeurs, veuillez nous envoyer un e-mail, nous vous répondrons bientôt.

        Maison

        Des produits

        À propos

        Contact