Fabricantes de fontes de alimentação

Driver de led de escurecimento triac série PE294R 3-12W

PE294 is one of the constant current dimming LED driver developed by my company with high power factor ,high efficiency, high precision, the use of the efficient stable low loss switch control chip and the high performance components makes it with low noise, energy saving, environmental protection, long life and other characteristics.

  • Marca:

    QINX
  • Item número.:  

    PE294R
  • Tensão de entrada:

    200-265Vac
  • Modo de trabalho:

    Corrente constante
  • Modo de escurecimento:  

    Triac dimmable
  • Tamanho:  

    104×39×26mm
  • Certificação:  

    AEA CE ROHS
Descrição dos produtos

Características:

  • LED phase-cut dimming driver, dimming range 2-100%
  • Suitable for RPC MOSFET dimmer and FPC TRAIC dimmer
  • PFC ativo
  • Protections: short circuit/over voltage/over current
  • Silica gel heat conduction technology,natural cold wind
  • Ultra small volume
  • Suitable for LED home lighting and commercial lighting
  • Safe no load protection device
  • Economic and convenient installation
  • conform to the world lighting equipment safety standards
  • Protection class II
  • 3 anos de garantia

General description:

PE280 is one of the constant current dimming LED driver developed by my company with high power factor ,high efficiency, high precision, the use of the efficient stable low loss switch control chip and the high performance components makes it with low noise, energy saving, environmental protection, long life and other characteristics.

█ Specification

Modelo     PE294R2435    PE294R4225     PE294R4230    PE294R24250     PE294R1570PR294R1570
   SAÍDAVoltagem de saída     12-24Vdc    25-42Vdc     25-42Vdc   12-24Vdc     6-15Vdc2.5-6Vdc
Tensão máxima de saída     24Vdc    42Vcc     42Vcc    24Vdc     15Vdc6Vdc
Non-load Output Voltage     27Vdc    45Vdc     45Vdc    27Vdc     19Vdc8Vdc
Corrente de saída     350mA    250mA     300mA    500mA     700mA700mA
Potência de saída     4.2W~8.4W    6.2W~10.5W     1.75W~4.2W    6W~12W     4.2W~10.5W1.75W-4.2W
Strobe Level      Lower flicker(8%)
Dimming Range      2~100%,
Current Accuracy      ±5%
Ripple & Noise      =500mv p-p
   ENTRADADimming Interface      Triac Leading edge/Tralling edge
Faixa de tensão de entrada      200-250Vca
Frequência      50/60Hz
Corrente de entrada      <0.072A    <0.08A      <0.08A      <0.08A<0.08A
Power FactorPF>0.9(at  full  load)PF>0.9(at  full  load)PF>0.88(at  full  load)PF>0.88(at  full  load)PF>0.88(at  full  load)
THD      230Vac@THD     <20% (at full  load)
      77%     79%      77%    77%      77%
Inrush Current(typ.)    Cold start 1.44A   Cold start 1.54A   Cold start1.54ACold start1.32A   Cold start1.54A
Anti-surto      L-N: 1.5kV
Corrente de fuga      <0,25mA/230Vca
AMBIENTETemperatura de trabalho      ta: 55 °C  tc: 85  °C
Umidade de trabalho      20 ~ 95%RH, sem condensação
Storage Temp., Humidity      -40 ~ 80  °C   , 10~95%RH
      ±0,03%/°C(0-50)°C
Vibração      10~500Hz, 2G 12min./1ciclo, período de 72min. cada um ao longo dos eixos X, Y, Z.
PROTEÇÃOProteção contra o superaquecimento      Intelligently adjusting or turning off the output current if the PCB temperature ≥110°C, , auto recovers.
Over Load Protection      Shut down the output when rated power≥102%, auto recovers.
Short Circuit Protection      Shut down automatically if short circuit occurs, auto recovers.
Non-load Protection      Shut down the output if no load, auto recovers when load back to normal.
SAFETY &
EMC
Tensão suportávelE/PO/P: 3750Vca
Resistência de IsolamentoE/PO/P: 100MΩ/500VCC/25°C/70%RH
Safety StandardsIEC/EN61347- 1, IEC/EN61347-2- 13
Emissão EMCEN55015, EN61000-3-2 Classe C, IEC61000-3-3
Imunidade EMCEN61000-4-2,3,4,5,6,8,11,  EN61547
Strobe Test StandardIEEE 1789
   OUTROSDimensão104×39×26mm(L×W×H)
Embalagem105*46*26.5mm
Peso (GW)68g

Dimensões :

 

Wiring Diagram:

█ Compatibility:

    Dimming system ModelWring 1 sampleWring 2 samplesWring 3 samplesDimmer ModelWring 1 sampleWring 2 samplesWring 3 samplesDimmer ModelWring 1 sampleWring 2 samplesWring 3 samples
Leviton  LNPWR-05BNFNFNFPanasonic WMY549NFNFNFBG DM400AP UKNFNFNF
Siemens 5WG1 528- 1DB01NFNFNF  Siemens 5UH82223-NC01NFNFNFCLIPSAL 32E540LMNFNFNF
JOBO dimming systemNFNFNFSimon 45E201NFNFNFCLIPSAL 32E540UDMNFNFNF
DALITEK  DM802NFNFNFOPPLE  P068102NFNFNFCLIPSAL 32E54TMNFNFNF
Lutron  QSGR-3PNFNFNFCABLOFIL VRCM2NFNFNFHPM CAT 400LNFNFNF
ABB  6197/12- 12- 101-500NFNFNFCDN X6-TG02NFNFNFKAOYI KDT-450ANFNFNF
Crestron  DIN- 1DIM4NFNFNFELKO 315GLEDNFNFNFLEGRAND 400TNFNFNF
Schneide  L5504D2ArNFNFNFELKO 316GLEDNFNFNFLEGRAND 400LNFNFNF
DAJIN  DC-TG0405CPNFNFNFPOL CAT634LMNFNFNFDIGINET DGLCDM400NFNFNF
Lite-Puter  EDX-F0411NFNFNFDETA Gr 100 UKNFNFNF
    Rmarks     Abbreviation: no flicker – NF, not compatible – NC, slight flicker – SL, flicker – F, strict flicker – SF

Note: due to the different power of dimmer and dimming system, the compatibility will be different. Before purchase, it needs to confirm
with the business to ensure the best matching effect of the product.

█ Wiring:

The output wire: 20AWG red and black PVC cable ,length 200-230mm,wire stripping requirement:5-7mm

The input wire : 20AW Brown Blue VDE double insulated wire, length 150-160mm,wire stripping requirement:5-7mm

The use of guidance:

**1:please pay attention to the distinction betweeninput and output,connect correctly,then power on

**2: please connect first the load of the DC output, open the powersupply after checking; in the constant current mode, if power on at open circuit,please turn off the power supply and can’t connectthe LED until the electric energy stored by the output release , or it may damage the LED;

**3:this type of power supply is only limited to the use of the LED lamps and lanterns, the input voltage range is AC200-250V, the

Specified output voltage, current range, the use environment temperature is -20-45 degrees,and the surface can not cover the

heat insulation cotton and other items that obstruct the heat dissipation of the product, which conforms to the product under the

conditions of the environment, this product enjoys three yearsof free warranty.

The abnormal conditions and the corresponding treatment methods:

l, the LED lamp doesn’t bright after the dimming driver is connected at the first time ,please turn off the AC input and check as follow:

a) Se há ou não mau contato na saída DC;

b) Se a polaridade da saída DC está invertida ou a placa de LED é soldada anti;

c)Whether AC input is bad contact;test after eliminating these failures.

2, the device has good connection, LED lights, but the LEDflicker, please turn off the AC input, then check the DC output;

a) sobrecarga, sob carga.

b) Se os parâmetros e os parâmetros reais correspondem ou não.

3,please timely communicate with us if you any questions inthe using,we will try our best to solve the problems with you.

Statement:

As imagens e especificações são apenas para referência, prevalecem em espécie, as especificações estão sujeitas a alterações com aviso prévio.

Deixe um recado

    Para saber mais sobre nossas fontes de alimentação / adaptadores de energia / drivers de LED / carregadores, envie-nos um e-mail, responderemos em breve.

    Produto relacionado
    100W TRIAC 0-10V 2 em 1 fonte de alimentação de escurecimento sem driver LED de cintilação

    100W TRIAC 0-10V 2 em 1 fonte de alimentação de escurecimento sem driver LED de cintilação

    Ele adota o controle da CPU e projeta uma variedade de modos de controle. O escurecimento é ativado e desativado lentamente. As matérias-primas utilizadas são marcas de primeira linha e design de escurecimento ultra profundo com chip importado. Combina com uma variedade de sistemas de escurecimento inteligentes e dimmers no mercado. O invólucro em liga de alumínio, rápida dissipação de calor, torna o equilíbrio térmico dos componentes mais estável.

    PE280 tamanho pequeno com driver de led de escurecimento triac compatível com ERP integrado

    PE280 tamanho pequeno com driver de led de escurecimento triac compatível com ERP integrado

    PE280 is one of the constant current dimming LED driver developed by my company with high power factor ,high efficiency, high precision, the use of the efficient stable low loss switch control chip and the high performance components makes it with low noise, energy saving, environmental protection, long life and other characteristics.

    Driver de led de escurecimento triac série PE294R 3-12W

    Driver de led de escurecimento triac série PE294R 3-12W

    PE294 is one of the constant current dimming LED driver developed by my company with high power factor ,high efficiency, high precision, the use of the efficient stable low loss switch control chip and the high performance components makes it with low noise, energy saving, environmental protection, long life and other characteristics.

    PE281 3-12W driver de led de escurecimento triac de tamanho pequeno

    PE281 3-12W driver de led de escurecimento triac de tamanho pequeno

    PE280 is one of the constant current dimming LED driver developed by my company with high power factor ,high efficiency, high precision, the use of the efficient stable low loss switch control chip and the high performance components makes it with low noise, energy saving, environmental protection, long life and other characteristics.

    PE296R series 12-18W triac dimming led driver

    PE296R series 12-18W triac dimming led driver

    PE296 is one of the constant current dimming LED driver developed by my company with high power factor ,high efficiency, high precision, the use of the efficient stable low loss switch control chip and the high performance components makes it with low noise, energy saving, environmental protection, long life and other characteristics.

    QINX

    Conecte-se conosco
    Se você está interessado em nossos produtos e deseja saber mais detalhes, deixe uma mensagem aqui, responderemos o mais breve possível.
    Maneira de entrar em contato conosco.

      Copyright © Qinx Technology Co., Ltd..Todos os direitos reservados.
      Bem-vindo ao QINX

        Para saber mais sobre nossos adaptadores de energia/drivers de LED/fontes de alimentação/carregadores, envie-nos um e-mail, responderemos em breve.

        Lar

        Produtos

        Sobre

        Contato